HOT ! 【30％OFF】 Amazon.com: Orion Separator Joint Ball 5pc Tech Motor ConstructionTools

• Special tool for removing tie rod ends from hub. Tie rod end puller that will not damage tie rod end boots
• It can also be used for ball joint pullers, etc
• This tie rod end puller is made of chrome molybdenum vanadium and is further hardened
• This is a tie rod end puller with confidence in strength
• Total Length: 6.5 inches (165 mm); Insert Width: 0.7 inches (19 mm); Weight: 19.7 oz (550 g); Lifting Weight: 1.6 inches (40 mm); Weight: Approx. 2.6 lbs (1

Special tool for removing tie rod ends from hub.

Tie rod end puller that will not damage tie rod end boots

It can also be used for ball joint pullers, etc.

Most common tie rod pullers on the market are due to lack of strength and damage to claws.

Tie rod part is always heated, so many cases may stick quite well.

This tie rod end puller is made of chrome molybdenum vanadium and is further hardened.

This is a tie rod end puller that is confident in strength.


■How to use■

It is very easy to simply insert the pin in the gap between the arm and the end, screw the bolt of the puller and hammer it with the hammer.

19mm wrench to turn bolts.


■Product Specifications ■

Total length: 6.5 inches (165 mm)

Insert Width: 0.7 inches (19 mm)

Lifting Capacity: 1.6 inches (40 mm)

Weight: 2.6 lbs (1.2 kg).

When working, it is a burden on the screw parts, so it is recommended that you apply a grease or similar to use.